Difference between revisions of "PrintrBot Play"
From Bloominglabs
(Nearing functional state.) |
|||
| Line 14: | Line 14: | ||
[https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex] | [https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex] | ||
| − | + | With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine. | |
| + | |||
| + | Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150. | ||
| + | |||
| + | |||
[[Category:Tools]] [[Category:3D Printers]] | [[Category:Tools]] [[Category:3D Printers]] | ||
Revision as of 10:02, 3 March 2017
A pre-assembled Printrbot Play (model 1505) was donated around 7 November 2016.
Documentation can be found on this Google Drive folder.
Printer has been in a nonfunctional state.
February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.
Reference reprap.org/wiki/printrboard
BootloaderHID.hex play-0.6.hex
With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine.
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.
