Difference between revisions of "PrintrBot Simple"

From Bloominglabs
Jump to: navigation, search
(Creating project page for the PrintrBot.)
 
m
Line 1: Line 1:
 
[http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)]
 
[http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)]
  
Uasful things to know:
+
Useful things to know:
 
USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.
 
USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.
  

Revision as of 09:42, 21 October 2015

PrintrBot Simple v1 (1310)

Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.

Serial is set up be 115200 baud.

Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:

M115

Reports Firmware installed.

M114

Reports position.

M119

Reports endpoint status.


cura software GPL AFFERO V1

Personal tools